Victron Energy - MultiPlus 500-1600VA, 24/1200/25-16 230V VE.Bus

~~8,454.45 NOK~~
6,367.66 NOK

VICTRON ENERGY PMP242120000, MultiPlus 500 VA - 1600 VA is the new MultiPlus and is intended to replace the previous MultiPlus Compact line.

Article number: PMP242120000

EAN: 8719076039327

Manufacturer: Victron Energy

Information
Reviews

VICTRON ENERGY PMP242120000, the MultiPlus 500 VA - 1600 VA is the new MultiPlus and is intended to replace the previous MultiPlus Compact line. It is a powerful pure sine wave inverter, a sophisticated battery charger that includes adaptive charging technology and an AC transfer switch in a compact housing, and is available in 500VA, 800VA, 1200VA, and 1600VA models.

Versatile, with intelligent power management
The MultiPlus is a powerful pure sine wave inverter, a sophisticated battery charger that includes adaptive charging technology and a high-speed AC transfer switch, in a compact housing. In addition to these primary functions, the MultiPlus also has several advanced features, as described below.

Parallel operation or three-phase capability
Up to six Multi units can operate in parallel to achieve higher output power. In addition to parallel connection, three units can be configured for three-phase output.

PowerControl - Managing limited generator, shore, or grid power
With the Multi Control Panel, a maximum generator or shore current can be set. The MultiPlus will then take into account other AC loads and use any extra current for charging, preventing the generator or shore power from being overloaded.

PowerAssist - Boosting the capacity of shore or generator power
This function takes the principle of PowerControl to a new dimension. It allows the MultiPlus to extend the capacity of the alternative source. Since peak power is often only required for a limited period, the MultiPlus will ensure that insufficient shore or generator power is immediately compensated with power from the battery. When the load decreases, the excess current is used to recharge the battery.

Adaptive four-stage charger and dual battery bank charging
The main output provides powerful charging to the battery system using advanced and adaptive charging software. The software fine-tunes the automatic three-stage process to suit the battery's condition and adds a fourth stage for longer periods of float charging. The adaptive charging process is described in more detail in the Phoenix Charger datasheet and on our website, under Technical Information. In addition, the MultiPlus charges a second battery by using a separate maintenance charge intended for the main engine or generator's starter battery.

High surge power
Required to start loads with high inrush current such as power converters for LED lamps, halogen lamps, or power tools.

Search mode
When search mode is activated, power consumption during no-load operation is reduced by approximately 70%. In this mode, the Multi switches off when operating in inverter mode, in the event of no load or very low load, and switches on every two seconds for a short period. If the output current exceeds a set level, the inverter will continue to operate. If not, the inverter will switch off again.

Programmable relay
By default, the programmable relay is set as an alarm relay, i.e., the relay will be de-energized in the event of an alarm or pre-alarm (the inverter is almost too hot, the ripple voltage on the input is almost too high, the battery voltage is almost too low).

Remote on/off charger on
Three-pole connection

Configuration, monitoring and control of the system on site
After installation, the MultiPlus is ready for use. Some settings can be changed with DIP switches. 500/800/1200 VA models: remote switch / battery charging voltage / inverter frequency / search mode. 1600/2000 VA models: battery charging voltage / search mode. Use VEConfig or VE.Bus Smart dongle for more settings.

Remote configuration and monitoring
Install a Cerbo GX or another GX product to connect to the internet. Operating data can be stored and displayed on our remote control website VRM (Victron Remote Management), which is also free. When connected to the internet, systems can be accessed remotely and settings can be changed.