Victron Energy - MultiPlus 500-1600VA, 12/500/20-16 230V VE.Bus

~~506.81 EUR~~
402.01 EUR

VICTRON ENERGY PMP121500000, MultiPlus 500 VA - 1600 VA is the new MultiPlus and is intended to replace the previous MultiPlus Compact line.

Item number: PMP121500000

EAN: 8719076046363

Supplier: Victron Energy

Information

VICTRON ENERGY PMP121500000, MultiPlus 500 VA - 1600 VA is the new MultiPlus and is intended to replace the previous line MultiPlus Compact. It is a powerful pure sine wave inverter, a sophisticated battery charger that includes an adaptive charging technology and an AC transfer switch in a compact housing and it is available in 500VA, 800VA, 1200VA and 1600VA models.

Versatile, with intelligent power management
MultiPlus is a powerful pure sine wave converter, a sophisticated battery charger that includes an adaptive charging technology and an AC transfer switch, high speed, in a compact housing. In addition to these primary functions, the MultiPlus also has several advanced functions, as described below.

Parallel operation or three-phase capability
Up to six Multi units can operate in parallel for to achieve higher output. In addition to parallel connection, three units can be configured for three-phase output.

PowerControl - Managing limited generator, shore or mains power
With the Multi Control Panel, one can set a maximum generator- or shore power. MultiPlus will then take into account other AC loads and use any extra power for charging, preventing the generator or shore power from being overloaded.

PowerAssist - Boost capacity for shore or generator power< br>This function takes the principle of PowerControl to a new dimension. It allows MultiPlus to expand the capacity of the alternate source. As peak power is often only required for a limited period, MultiPlus will ensure that insufficient shore or generator power is immediately compensated with power from the battery. When the load decreases, the excess current is used to recharge the battery.

Adaptable four-stage charger and dual battery bank charging
The main output provides a powerful charge to the battery system using advanced and adaptable loading software. The software fine-tunes the automatic three-step process to suit the state of the battery and adds a fourth step for longer periods of float charging. The customizable charging process is described in more detail on the Phoenix Charger datasheet and our website, under Technical Information. In addition, the MultiPlus charges a second battery using a separate trickle charge dedicated to the main engine or generator starter battery.

High starting power
Required to start high inrush current loads such as power converter for LED lamps, halogen lamps or electric tools.

Search mode
When the search mode is activated, the power consumption during no-load operation is reduced by approximately 70%. In this mode, the Multin shuts down when operating in inverter mode, in the event of no load or very low load, and starts up every two seconds for a short period. If the output current exceeds a set level, the inverter will continue to operate. If not, the inverter will shut down again.

Programmable relay
By default, the programmable relay is set as an alarm relay, i.e. the relay will be de-energized in the event of an alarm or pre-alarm (inverter is almost too hot, input hum voltage is almost too high, battery voltage is almost too low).

Remote On/Off- charger on
Three-pole connection

Configuration, monitoring and control of the system on site
After installation, the MultiPlus is ready for use. Some settings can be changed with DIP switches. 500/800/1200 VA models: remote switch / battery charge voltage / inverter frequency / search mode. 1600/2000 VA models: battery charging voltage / search mode. Use VEConfig or VE.Bus Smart dongle for more settings.

Remote configuration and monitoring
Install a Cerbo GX or another GX product to connect to the Internet . Operating data can be stored and displayed on our VRM (Victron Remote Management) website, which is also free. When connected to the internet, systems can be accessed remotely and settings can be changed.

< /p>